Jumbo loan limits by state are a misleading phrase, because the limit is set county by county. The same $900,000 home can be a conforming loan in one county and a jumbo loan in the next, which changes your rate, down payment, reserve requirements, and approval path. These seven strategies show homebuyers and homeowners in Virginia, Florida, Tennessee, and Georgia how to find their real limit, decide whether to stay under it, and shop jumbo financing through a broker with access to 500+ wholesale lenders. One note on who runs this site: Up Lending by Duane Buziak is a mortgage broker, not a comparison aggregator, so the advice below comes from someone who structures these loans for a living.
By Duane Buziak, NMLS #1110647. Figures are as of 2026 and should be verified against the linked sources before you act.
1. Look Up Your County’s Limit, Not Your State’s
The conforming loan limit is the maximum loan size Fannie Mae and Freddie Mac will buy. The Federal Housing Finance Agency (FHFA) sets a national baseline each year and raises it in counties where home prices run high, up to a ceiling of 150% of the baseline. As of 2026, the baseline for a one-unit property is $832,750 and the ceiling is $1,249,125, per the FHFA conforming loan limit values page. A loan above your county’s limit is a jumbo, or non-conforming, loan. A loan between the baseline and a high-cost county’s limit is called high-balance conforming.
For an illustration, a county in a high-cost part of Northern Virginia can sit at or near the ceiling, while a lower-cost Tennessee county sits at the baseline. Two buyers with identical $900,000 loans can land in different categories. Confirm the exact figures on FHFA rather than trusting this paragraph.
To look up your limit:
- Open FHFA’s conforming loan limit lookup and select the current year.
- Choose your state and county, not a nearby city or metro area.
- Write down the one-unit limit and, if relevant, the two-, three-, and four-unit limits.
- Compare them to the loan amount you plan to borrow.
The common mistakes are using a statewide number, relying on an article that quotes last year’s limits, and forgetting that 2-4 unit properties carry higher limits. A buyer purchasing a duplex may be conforming at a price that would be jumbo for a single-family home.
What to measure: your planned loan amount minus the county limit, in dollars. A positive number means you are over and have decisions to make. A negative number means you have room, which is useful if fees are financed.
2. Calculate Your Loan Amount, Not the Purchase Price
Limits apply to the mortgage balance, not the price of the home. That means your down payment is a lever. Putting more down can pull a loan under the limit and into conforming pricing and guidelines, which often means lower reserve requirements and more flexible credit standards.
Suppose you buy a $950,000 home in a county with an $832,750 limit. With 10% down ($95,000), your loan is $855,000, which is $22,250 over. To land exactly at the limit, your down payment would need to be $117,250, or about 12.35% of the price. Rounding up to $117,500 gives a $832,500 loan. The extra cash required is about $22,500 compared with 10% down.
Put the sequence in order:
- Subtract your planned down payment from the price.
- Add any fees that will be financed into the balance, such as a VA or FHA funding fee.
- Compare the total to your county limit.
- Get a quote at each loan amount and price the extra cash against the rate difference.
The classic pitfall is hitting the limit on paper and then watching a financed fee push the balance back over it. Leave a cushion of a few thousand dollars below the limit.
Also, do not drain your reserves to get under the line. Jumbo-sized borrowers often need cash reserves anyway, so stripping them to save on rate can backfire.
What to measure: the extra cash required against the monthly payment savings and the reserves you keep. If $22,500 more down saves a modest amount per month but cuts your emergency fund in half, staying jumbo may be the better call.
3. Compare Conforming, High-Balance, and Jumbo Pricing Side by Side
Many borrowers assume jumbo means a higher rate. Sometimes it does. But jumbo loans are priced by investors who want well-qualified borrowers, and some jumbo programs have priced competitively with high-balance conforming loans for strong-credit buyers. The only way to know is to ask for quotes in each tier you qualify for. The CFPB’s jumbo loan explainer covers the basic definitions if you want a neutral reference.
Imagine a borrower with a 760 score who needs $860,000 in a county where the limit is $832,750. A high-balance conforming product is not available because the loan is over the limit, so the borrower is comparing a jumbo against a larger down payment that brings the loan under the limit. Each path can come with different minimum down payments, different reserve requirements (jumbo often asks for several months of payments in the bank), and different score cutoffs. The cheapest rate is not always the cheapest loan once cash to close is included.
To compare properly:
- Request quotes for every eligible tier with the same points and the same lock period.
- Build a simple list for each: rate, APR, cash to close, required reserves, minimum score, and mortgage insurance if any.
- Ask what each option assumes about property type and occupancy.
- Choose on the full picture, not the headline rate.
The mistake is skipping the comparison because jumbo “must” cost more, or comparing a quote with zero points to one with two points. Uneven quotes mislead.
What to measure: APR and total cash to close for each tier. APR folds in some costs a rate leaves out, and cash to close shows what the choice demands today.
4. Use Government Loan Limits Where They Fit
VA, FHA, and USDA loans follow their own rules, and those rules can change what “jumbo” means for you. A VA loan is the most striking case. Per VA.gov’s loan limits page, veterans with full entitlement have no VA-set loan limit. That does not mean unlimited approval: the wholesale lender funding the loan still sets guidelines, and your income and credit still have to support the payment.
For an illustration, an eligible veteran with full entitlement buys a $1,050,000 home in a county where the conforming limit is lower. Financing through VA can allow a purchase above the conforming limit with little or no down payment, subject to the funding lender’s overlays and the veteran’s income. A conventional jumbo for the same home could ask for 10% to 20% down.
FHA and USDA work differently. FHA has county limits you can check on HUD.gov’s FHA limit lookup, and they usually sit well below jumbo territory in most counties. USDA is capped by income and property location, so confirm the address on the USDA eligibility site.
- Confirm entitlement through VA.gov and request a Certificate of Eligibility.
- Check FHA limits for your county and USDA eligibility for the property.
- Have a broker match the program to a wholesale lender that is comfortable with large balances.
The common mistakes are assuming a VA loan has a hard dollar cap, and assuming every funding source offers the same large-loan terms. They do not.
What to measure: down payment and monthly payment under each program compared with a conventional jumbo, including funding fees and mortgage insurance.
5. Consider Piggyback or Second-Lien Structures
A piggyback keeps the first mortgage at or below the conforming limit and covers part of the down payment with a second lien, such as a fixed-rate second mortgage or a HELOC. The first loan gets conforming guidelines. The second loan fills the gap between your cash and the price.
Suppose you buy a $1,000,000 home with $100,000 down. Instead of a $900,000 jumbo, you take an $800,000 first mortgage, which is $32,750 under an $832,750 limit, plus a $100,000 second lien. This is often called an 80/10/10 structure: 80% first, 10% second, 10% down. If the first sits in conforming territory, you may avoid some jumbo reserve and credit overlays, though the second lien carries its own guidelines.
- Confirm that wholesale options exist for both the first and the second at your credit profile and loan-to-value.
- Get the second lien’s rate type, term, and any draw or interest-only period in writing.
- Add the two payments together and compare them to the single jumbo payment.
- If the second is variable, model a payment at a rate several points higher than today.
The mistake most buyers make is underestimating the second lien. Seconds usually carry higher rates than first mortgages, and a HELOC rate can move with the market. A blended payment that looks better today can look worse after a few rate changes.
What to measure: your blended monthly payment and total interest over the time you expect to hold the loan, compared with the single jumbo. If you plan to pay the second off within a few years, the comparison can tilt in favor of the piggyback. If you will carry it for a decade, run the numbers carefully.
6. Explore Non-QM and DSCR Options When Jumbo Guidelines Don’t Fit
Sometimes loan size is not the real obstacle. Self-employed borrowers with heavy write-offs, investors with several properties, and buyers with income that does not show cleanly on tax returns can struggle with standard jumbo documentation. Non-QM loans (non-qualified mortgage loans) use alternative documentation such as bank statements or asset statements. A DSCR loan, short for debt service coverage ratio, qualifies an investment property on its rent rather than your personal income. Foreign National loans serve buyers without a U.S. credit history or income documentation.
For an illustration, take a rental that brings in $5,400 a month with a total PITIA payment (principal, interest, taxes, insurance, and association dues) of $4,500. The DSCR is $5,400 divided by $4,500, or 1.20. Many DSCR programs look for a ratio at or above 1.0, and stronger ratios can improve pricing, though each wholesale lender sets its own minimums.
- Gather a lease or market-rent analysis for investment properties, or 12 to 24 months of bank statements for self-employed income.
- Pull asset statements for any program that qualifies on assets.
- Ask a broker to screen non-QM, DSCR, and Foreign National options side by side with a standard jumbo.
The mistake is reaching for non-QM when a standard jumbo would have qualified at a lower cost. Non-QM pricing generally runs higher because the documentation is lighter, so it should be the fallback, not the first stop. These products also do not apply to every owner-occupied purchase.
What to measure: your DSCR or qualifying income, plus the rate and down payment against a standard jumbo quote. If the premium is small and the paperwork saved is large, non-QM can be worth it. If the gap is wide, work on fixing the documentation problem first.
7. Shop Through a Broker With Soft-Pull Pre-Approval and Wholesale Access
A mortgage broker does not fund loans from one rate sheet. Duane Buziak places loans with 500+ wholesale lenders, so one conversation can surface conforming, high-balance, jumbo, piggyback, and non-QM paths. That matters most near a county limit, where the best answer is often a different structure rather than a better rate.
The other piece is credit protection. Duane Buziak uses the NoTouch Credit Pull, which is a soft credit pull mortgage review: it looks at your credit profile without a hard inquiry, so it does not ding your score. This gives you a mortgage pre approval without hard pull until you choose a specific option. It is a no hard inquiry mortgage pre approval path for comparing real options, not a loan commitment.
Here is how the two approaches compare:
- Product range: a broker can compare hundreds of wholesale rate sheets. Rocket Mortgage and Movement Mortgage offer one company’s product set, which is simpler but narrower.
- Credit inquiries: a soft pull review first, with a hard pull only for the chosen option. Single-shelf retail applications typically require a full application and a hard pull to get a firm quote.
- Digital experience: large retail companies have polished apps and in-house servicing. The NoTouch Credit Pull gives digital parity at the shopping stage.
- Credibility: Duane Buziak ranks #114 on the Scotsman Guide Top Originators list and was VA Broker of the Year 2024-2025.
- Watch-out: Duane Buziak is licensed in Virginia, Florida, Tennessee, and Georgia only, so buyers elsewhere need a different broker.
- Call Duane Buziak at 804-212-8663 if you are buying in Virginia, Florida, Tennessee, or Georgia.
- Share your goals, property details, and documents.
- Review the options from the soft pull mortgage broker review.
- Authorize a hard pull only for the option you pick.
The mistake is applying with several single-shelf companies and collecting multiple hard inquiries. What to measure: how many distinct options you compared, how many hard inquiries you incurred, and your final APR.
Eight Questions Buyers Ask About Jumbo Limits
What is the jumbo loan limit in 2026?
There is no single limit. As of 2026, the baseline conforming limit for a one-unit property is $832,750, and high-cost counties go up to $1,249,125. Any loan above your county’s limit is a jumbo. Check your county on FHFA.
Do jumbo loan limits vary by state?
They vary by county. Counties in the same state can have different limits, so look up the county where the property sits.
Are jumbo rates always higher than conforming rates?
No. Jumbo rates can be close to conforming rates, or occasionally lower, for strong borrowers. Compare quotes in every eligible tier instead of assuming.
How much down payment do I need for a jumbo loan?
It depends on the program, your credit, and the property. Jumbo guidelines often ask for more down than conforming loans, and some also require several months of reserves. A broker can show you the minimums across wholesale options.
Does VA have a loan limit?
Not for veterans with full entitlement, according to VA.gov. The funding source still sets its own guidelines, and your income must support the payment.
What is high-balance conforming?
It is a conforming loan that exceeds the national baseline but stays within a high-cost county’s higher limit. It follows Fannie Mae and Freddie Mac guidelines instead of jumbo guidelines.
Can I check my options without a hard credit inquiry?
Yes. Duane Buziak‘s NoTouch Credit Pull is a soft credit pull that reviews your profile without a hard inquiry. A hard pull comes only after you choose a loan.
Where does Duane Buziak work?
Duane Buziak is a licensed mortgage broker in Virginia, Florida, Tennessee, and Georgia. In Florida, he is a Florida-licensed broker serving clients statewide, not an in-person office.
Where to Start: Two Free Steps, Then Real Quotes
Begin with Strategy 1 and Strategy 2. They cost nothing and shape every other decision: you cannot judge a piggyback, a government program, or a jumbo until you know how far over or under the limit your loan sits. Once you have that number, use Strategy 7 to collect real quotes through a soft pull, then decide among staying conforming, going jumbo, or using a piggyback. Skip non-QM unless documentation, not loan size, is what blocks you.
Ready to experience a fast, simple, and stress-free path to homeownership or refinancing? Connect with our trusted mortgage experts today and discover the right loan solution tailored to your unique financial situation, whether you’re a first-time buyer, seasoned investor, or anywhere in between.
